Case for FrSky RX6R receiver

This is a minimalist case for the FrSky RX6R. Two versions are provided, one with access to the S-Port socket (as shown), and one without.

The case fits receivers with PWM ports and bind button on the same side of the board (this is the most common arrangement).

Instructions: 

1. Remove the card wrapper from receiver, cut a piece 21 x 18 mm - this will be the new bed
2. Print the case
3. Lay the bed (from step 1) inside the bottom half
4. Place the rx board over the bed
5. Locate the top half and secure with tape or cyano
6. Apply hot glue to the antennae exits

See screenshot for Cura slicer settings.

See also my case for the G-RX6.

Print Settings

Printer Brand:

Creality

Printer: 

CR-10 Mini

Rafts:

Doesn't Matter

Supports: 

No

Infill:

Use default (not critical)

Filament:

Creality PLA 

Category: Models