Collapsing Swords and Lightsabers Test Print

If you can successfully print this with NOTHING attaching the rings together, then you should be able to successfully print the print-in-place version or the blades concentrically.  

There is a new “clearance” test print, you can find here. I would use that print to test your printers ability to print a clearance, and this print to better tune the seam. 

Be sure to to look closely, even if nothing is attached try tuning for the smallest seam. 

The test print is a total of 24mm high so I change settings every 8mm(3x)  then compare the changes until I achieve the best result. The settings that will have the most impact are; flowrate, retraction distance/speed, coast, wipe, and extra restart distance.  You may also try; seam location, speed, temperature, and z-hop.

Find detailed instructions on how to print collapsing swords on my website. 

Do not repost, distribute, sell or trade the files or physical models of this object.