WSPR Hot Swap Afterburner

A Afterburner for a WSPR that can be hot swapped to a regular WSPR.
Use the alt front for barrel swaps.
Wiring diagram is similar to a stryfe. Can also use a stryfe motor braking wiring diagram to make reloading faster.
Micro switch is just glued on the side like the photo.
Battery is just held in by rubber bands.
Bend the lever on the micro switch to make it angled.
The flywheel set up in the picture is 2 CC wheels and 2 neo-rhinos

Hardware-
2 motors
2 flywheels. Cage is a 43.5 dominator base. Use lower crush wheels so you can stick darts through the flywheels.
4 10-32 caliburn screws
6 10-32 nuts
lever micro switch
6 inch caliburn barrel for flywheel portion and whatever other barrel for the regular mode.
18g or lower silicone wire.
heat shrink
whatever battery to go with the motors and connectors for it.
superglue
loctite of some kind
flywheel cage screws x4some rubber bands
optional- 2 10-32 thumbscrews for hot swap feature.

Crediting Ofp here because thingiverse doesn't have a remix on here.

Remix of https://www.thingiverse.com/thing:3800202

Print instructions

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

No

Supports:

Yes

.1-.2

Infill:

15-20

Notes:

Flywheel cage requires supports from buildplate

Other parts don't need support.

Reorientate parts like in 3 photo