Dungeons and Dragons: The legend of Drizzt board game inserts

This is a set of inserts/holders for the board game Dungeons and Dragons: The legend of Drizzt. The game has a lot of figurine but sadly doesn't come with a safe way of storing them away. So I decided to make a set of inserts/figurine holders to store them away safely within the original box.

The inserts are slightly higher then the box, this is by design as I found this the best solution for storing the double sized tiles.

Print instructions:

The figurine holders and tile holders can simply be printed in 0.2mm layer height with an 0.4mm nozzle.

Most sleeves are designed to be printed in vase mode, with an external perimeter extrusion width of 0.8mm. This can be done perfectly fine with an 0.4mm nozzle and the added thickness will prevent the walls from becoming “wobbly” during printing.

The card boxes can be printed in 0.2mm as well, but I recommend print the lids in 0.1mm as it cause the lip keeping it close to be better rounded and work a lot smoother.

The sleeve for the BBE is larger and the walls are likely to become a bit wobbly even with 0.8mm extrusion width. I've designed to either be printed in vase mode with a larger nozzle (0.6mm or larger) and 1.2mm external perimeter width or with a 0.4mm nozzle as a normal print with no top layers, no infill and 3 wall perimeters.

The 2 fillers are intended to printed in the same way as the BBE sleeve. They store all the small cardboard bits.

required amounts of parts are in the part descriptions. See the pictures for the arrangement in the box.