Clean design toilet paper holder

A very reduced design of a toilet paper holder. The fastening mechanism and the screws are completely invisible and do not interfere with the straight lines.

Can handle a fairly wide range of screw spacing, ideal for replacing an old one. Hole diameter (screws up to) 4.4mm

Maybe set infill a bit higher for more stability.

! Mounting has a top and a bottom side (enlarges to the bottom).

Slide the holder down on the mounting with a little bit of pressure.

Supports: There is a tricky area with some printing in the air but I put in two manual supports for the most dangerous part and the result is on the inside afterwards, so not critical. If your printer has a good cooling you won't need any supports.

Update 2023-08-02: Little bit thicker supports