(Add-On) Better Ender Sonic Pad Mount

So, I didn't not have the EXACT M3 Heated Brass Inserts the RandyMay used in his original design. Because of this, I could never tighten the SP struts to the printed walls the inserts are heat pressed into though they do at least have M3 inserts. Since I couldn't tighten it down all the way, my Sonic Pad was FLOPPY. 

With how high my Ender 5 S1 is, I didn't need it to be aimed at a high angle at all so I kept set straight for me. 
Provided you did make the Better Ender Sonic Pad Mount: https://www.printables.com/model/435500-better-ender-5-s1-sonic-pad-mount

 One end goes around the 21 mm cubed front extrusion, the other which is only 9mm deep is where the sonic pad will sit snugly. If you are ok with the Sonic Pad pretty much sitting straight horizontal with no angle up or down, this will work perfectly for you. 

If you need a high angle, You are more then welcome to remix it to whatever angle you like. 
I might be moving soon meaning the table my E5S1 is on may not be the same after the move so I may make a higher angled one in the future if it is deemed necessary. 


Enjoy!