gerber multiplier sheath

Remixed from another model where he did all the hard work, I just modified it to fit my personal preference, I wanted a belt clip that fit horizontal instead of vertical so I reoriented the clip and opened the bottom side and reinforced the top so it can slip on the belt, also added holes for m3 heatset inserts for some elastic retention but evanphi did a great job with the original model and I didn't need it, also printed vertically as I uploaded it it doesn't need supports and the layer orientation gives it the most strength possible.

Make sure to check out the original model as well! 

I'm very new to modeling, so far I've only dabbled in remixing other models so any feedback would be greatly appreciated