Insta360 Go 3 Tripod

Permanent Magnets: 10*3mm

• Note the NS pole of the magnet

An M5 x 40mm bolt is needed for assembly (longer works too, but it will stick out and look ugly). Assembly:

Fasten the legs first, as this can require a bit of force. Place the tripod base upside down on a flat surface. Be sure to align the notches of each leg witch the small bumps inside of the grooves for the legs. Press straight down, but be careful so you don't hurt yourself if something slips. Using leather gloves might be a good idea.

• The ball-joint should connect without excessive force, if needed you can use a screwdriver to slightly widen the gap while pushing it into place.
• Side the M5 bolt through the printed screw. If it's difficult to get the last bit of the bolt head seated, use an M5 nut on the other end to pull the bolt through.
• The bolt hole is threaded in the design, but depending on your printer settings, it might be a bit tight. You can put a small amount of grease on the very end of the bolt for smoother operation.