Titan submersible- mini keychain edition

Introducing the Titan submersible - Mini keychain addition 

Made this model for a STEM workshop event, hesitant to make it at first, but surprisingly my team approved of the idea, and thus here we are. Happy printing. 

MATERIALS:

• 1x keychain ring 
• Super glue (or your glue of preference)

PRINTABLE PARTS:

• X1 Body 
• X1 Lid
• X2 ThrusterUp
• X2 ThrusterForward 
• X2 Support 
• X2 Feet

MY PRINT SETTINGS:

• 0% Infill (if you want stronger print at 20%, for me, 0% is plenty strong)
• I use 0.6mm Nozzle width, 2 perimeters 
• Generic PLA
• Sequential printing enabled (One by one printing)
• Seam position to “rear” (Find at print settings>layers and perimeters>Advanced>seam position). You must be in “expert mode” and orient print so that the face facing you is the good side and the seam at the rear.