Adventure Force Jurassic Pro muzzle for longer barrel

This is a muzzle for an Adventure Force Jurassic Pro that allows for a longer aluminum barrel. the only difference between the stock one is that the stock muzzle has a stop that keeps the stock aluminum barrel in place, however, this stop doesn't allow for a longer aluminum barrel, and this 3d printable muzzle doesn't have a stop meaning you can upgrade to a longer barrel. to install the muzzle, simply take out the stock one by removing the single screw holding it in, then take your new fancy 3d printed one and fit it into place (this may require mild sanding to the slots for the ribbings on either side of the shell depending on print quality), and finally take the screw that was holding the stock muzzle in place and put it into the new muzzle to hold it in place. you will probably want to glue your new aluminum barrel into the dart gate because friction is now the only thing holding your barrel in place. with this muzzle you can still use the barrel extension included with the Jurassic Pro.

BARREL RECOMMENDATIONS: I recommend that you use a kuryaka barrel (unchambered) from either Kurykafe's on Etsy or from Out Of Darts, however, any aluminum barrel with an Inner Diameter of ~13mm and an outer diameter of 16mm should work fine. I have found that 1/2" cpvc fits into the dart gate and should work with the muzzle, however with my testing, it seems the dart fit is not ideal for the blaster and the stock barrel is more reliable.

TL;DR put the fancy thing in the blaster and use a kury barrel, not cpvc.

Print Settings

Printer:

Ender 3 V2

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

1.6

Infill:

30

Filament:

orange