Meater steam wand clip

Updated clip to attach a Meater smart temperature probe to an espresso machine steam wand. The model has been modified to be a single part instead of a magnetic detachable mount and can be printed and used in one piece with no post processing or additional hardware.

One variant has a clip for the steam wand and requires the probe to be slid in and out, this works well with o-rings on the Meater to keep the probe at a specific height.

The other variant has a clip on both sides so the probe can be attached and detached very easily to make charging the probe more convenient. In this configuration the probe tends to slide down to the lowest point but the clip on the steam wand can be adjusted to compensate easily. I use this variant on my espresso machine.

Print Settings

Printer Brand:

Snapmaker

Printer:

Snapmaker 2 A350

Rafts:

No

Supports:

No

Resolution:

0.1mm

Infill:

10%

Filament: Prusament PLA