ARTICULATED poison DRAGON flexible

cool

Printed with supports, great toy, thanks

I absolutely love this model! The only bad thing was that it was so hard to print, i had to restart the printing like 10 times.

Works really well for tricolor filaments due to all the details. Thanks

Loves to hang in the plants

Zmenšení na 76%, pla, vypadá a funguje skvěle.

Top👍

Nice, thx! (edited)

I used rainbow PLA and billow fuzzy skin and am pleased with the results. I had to use support, tree hybrid, and it was a bit of work to take them off, nothing my exacto couldn't handle, just needed to put it in the correct angle to remove from the links.

I printed mine on a Flashforge ADV 5m (very new to this) and used supports with the recommended values. It printed great, but the supports are impossible to pry off. A lot of the plastic is still stuck in small spots. I see a lot of beautiful prints of this on here. Did you all use supports? Are there settings I should look at to reduce the supports?

Printed well. Took longer than expected, but turned out really well. Love it!