WUBEN X2 EDC tactical belt holster

A snug and solid fit for your WUBEN X2 EDC flashlight on your belt.  Easy and quick  to access anytime you need it. Secured by friction and an additional snap mechanism. 

The holder features water drain holes so water does not collect at the bottom of the case. 

The Belt mount I got from cults and you have to buy it there: 

https://cults3d.com/en/3d-model/tool/tactical-belt-clip-print-in-place

All you need for this build is some superglue, a 2,5 mm drill bit, 3x M4 washers, 3x M3 screws with a length of 10mm  and a Stripe of fabric tape.

fabric tape: 

https://www.amazon.de/-/en/51608-Fleece-Insulating-harnesses-adhesive/dp/B00PAC9OAK/ref=sr_1_5

Place the print it place belt mount from cults  on the back of the case and align the top middle hole with the pre printed hole on the main case and drill a hole with the 2.5mm drill bit. 

Next use the drill to tap two holes on the lower left and right side into the case ( check pictures)   Use the washers and the screws and glue them in  with superglue ( the threads alone I would not trust on this to remain secure) 

 Placed a small square of rubber sponge on the clip mechanism in between the main holder and the belt mount (check pictures).  Add a stripe of fabric tape  on the front facing inner side of the case for a tight fit.