Ssupd Meshroom IcemanCooler reservoir mount

This model allows mounting of the Iceman Cooler pump/reservoir combo onto the backside of the Ssupd Meshroom case.

Unlike the ssupd marketing material, I chose to mount this onto the Horizontal PCI card slot by removing the existing plates and made this design.

(The image features an older revision of the model where I realised I had space to make a cable management channel, the model has been updated to have this channel modeled and some structure added for rigidity.)

Printing:

• No real challenge in printing, I used 0.2mm.
• Brim should not be necessary as it is a large flat object.
• recommend material that is unlikely to warp from exposure to heat. I used prusament ASA.

Mounting:

• The three screws from the PCI card cover can be re-used.
• The mount is screwed in from the inside of the case.
• Screw the reservoid using the two lower screw holes, refer to image, top screw holes are not used.
• Route the pump molex and pwm cable through the very bottom channel
• Make sure your angled fittings can clear the mount as the mount should be +/-2.2mm wide with a small gap for the case metal width