Paw Stencil for liquid chalk spray

This modell is to make paw prints on the pavement, so the kids can follow the trail and find the treasure. The model has a holder and a wall to prevent overspray on the side. Also a risen conture to prevent bleeding on the pavement.

Also it features a spout to empty the overspray into the spraybottle again.

I printed it in 3DJake White PETG on the Prusa Mini, as the PETG might be better to clean i thought. Takes about 3h to print.

Recipe

Just mix (any) starch with about the same amount of water. Add food coloring to the mix if you want. But you need to add quite a bit, as it does not really comes through.

How to use

1. Put the mixed solution in a spray bottle. 
2. Put the stencil on the street, spray until the floor is wet, let dry, the picture is better visible when dried.
3. If there is to much fluid in the stencil, fill it back in the bottle.
4. repeat

I included a blank stencil “pan” for you to make your own stencil maybe in PrusaSlicer.