This holder works for a single or dual El Gato Stream Deck. Pan-Tilt adjustable. The front frame hides the logo to allow for a better looking upside-down mounting.
To assemble it after printing, you will need:
1) Stream Deck Frame + Holder assembly:
A) To hold the frame to the main bracket:
4x M3x15 bolts
4x M3 nuts
B)To hold the frame+bracket assembly to the mid-hinge:
1x M6x75 bolt
1x M6 washer (optional, helps with friction)
1x M6 wedge lock washer (optional, strongly recommended for friction)
2) Mid-Hinge:
1x M6 Square nut (1 per holder)
3) Clamp:
A) To hold the mid-hinge to the clamp:
1x M6x60 bolt (or longer, fully threaded recommended)
1x M6 fender washer
1x M6 nut
B) The clamp assembly
1x M8x40 bolt (minimum length)
1x M8 nut
1x M8 printed knob (https://www.thingiverse.com/thing:2223672 or equivalent)
1x M8 printed clamp foot (https://www.thingiverse.com/thing:2532336)
Remixers: This model was built with OpenSCAD, and I didn't have a reliable way to make a 3D printable bolt for the clamp. A redesign would be welcomed.
The author marked this model as their own original creation.