EDIT 27/6/2021
Okay, it is time to actually go ahead and finish this design, I looked around thingiverse for better design inspiration, I found a design but had to design it in CAD by myself,
3 pieces now, you will need:
-Super Glue
-M5 Nut
-M5x20 Bolt
The Ball will need adhesion support,
The side piece doesn't anything,
Arm only needs supports in the vertical part where the ball will sit, use a Cura plug in to disable supports for the M5 Bolt, or prepare to clean out with a drill.
Smooth your ball if you want to, I just ground it against the ball plates until it felt smooth, you will want to place four 4 dots of super glue in each corner of the arm's ball plate, insert the ball and squish with the other plate. add more superglue to any gaps.
I have deleted the old text, its completely redundant and frankly embarrassing
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Yes
Supports:
Yes
Resolution:
0.2
Infill:
20%
Filament: TINMORRY PETG C-Transparent
Notes:
Personal Temps,
235/75
This will work with PLA as well
Category: Kitchen & DiningThe author marked this model as their own original creation. Imported from Thingiverse.