Uniphoxx Slingshot band clamp

If you are getting a lot of frame hits because you suck at tying bands to the forks like me, you would probably want a…
2
9
0
150
updated August 18, 2024

Description

PDF

If you are getting a lot of frame hits because you suck at tying bands to the forks like me, you would probably want a set of band clamps, you can buy some official ones from wasp slingshots but if you want to print some here it is,

print both the washer and the clamp twice for each fork, if you shoot TTF just rotate the clamp, I suggest using some super glue to glue the M5 Nut onto the clamp piece, M5x20 bolts are used, don't over tighten too much as it will break your frame

Print Settings

Rafts:

No

Supports:

Yes

Resolution:

200

Infill:

40

Filament: eSun PLA+ Gray


Notes:

print washer side down, with supports to leave the surface with the notch smooth

Post-Printing =============

If you are getting uneven clamping, feel free to use a knife and skim off the two strips of plastic to shape it a bit better

Category: Sport & Outdoors

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License