REMIX OF https://www.thingiverse.com/thing:1060861
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Yes
Supports:
No
Resolution:
200
Infill:
10
Filament: TINMORRY PETG C-Transparent
Notes:
PLA also works, the original was made with PLA and is much stiffer
Category: Audio
The author remixed this model. Imported from Thingiverse.
The original design is good but I found that it had a few weakenesses, namely the microphone cable at 90 degree angle which would break without any strain relief.
My remix now requires you to loop the wire and use a zip tie to hold the wire onto the arm, a shoulder is added for the ziptie to sit against so it doesnt slide.
I have also changed the dimensions of the magnet used, it is now 7x2mm, I have added 0.25mm of tollerance in both the arm and the mount, on my test print it sat perfectly in place.