Grip Clip Iron Stand

I essentially put the clips that hold the TS100 inside the original case on top of the existing TS100 stand that's included in that fine box.

My motivation for this was that when using the soldering iron for extended periods of time, the 608 bearing that interfaces the soldering tip with the original stand tended to get hot enough to soften the PETG material of the stand.
This version directly clips onto the grip of the TS100 and shouldn't really get hot.

I found the easiest way to free the TS100 from the stand is to tilt it backwards (power input side down) until it releases.

Just to be sure I opted for 3 perimeters but I think 2 should be totally fine. Otherwise I left the settings as default using 0.15 mm quality settings printing PETG on my Prusa MINI.