3D Models 3D Printers Bambu Lab Parts & Upgrades

BambuLab HEPA Carbon Filter (compatible with Alveo 3D filter)

0 reviews

INSIDE EDITON

@INSIDEEDITON_1043988

This is a HEPA filter holder that is mounted on the rear of the BAMBU LAB 3D printer.

707

updated July 16, 2023

Description

PDF

This is a HEPA filter holder that is mounted on the rear of the BAMBU LAB 3D printer.
The holder can be equipped with an Alveo3D filter EN-1822 or a HEPA filter H13, and a carbon filter.

These models have a holder for filter and a stand that supports holer safely. (Alveo filter is 124mm x 124mm x 41mm standard)
The holder can be attached with a neodymium magnet. In addition, for safer mounting, a stand was built underneath to enhance mounting stability.

Motivation

When the Hepa filter is installed on the rear fan of the BAMBU 3D printer, air resistance is generated without fan. so efficient air exhaust is not achieved.
To acheive efficient air exhaust, it requires a extra fan that can be forced out.
Also, the fans, itselt is heavy, so you need a stand to support holder(fan).

What you need (where to buy)

The following is what is required for production.

1. Neodymium magnet: Square magnet 20 mm (W) × 8 mm (H) × 3 mm (D)
If it is difficult to get the above magnet, please modify the model to fit the magnet size.