Clothepin

Printed using 4 perimeters for solid legs. Supports are needed, organic supports are recommended. They need only a low amount of material and are easily be removed.

Put the flat marked surface onte te printbed.

Use ASA or PETG for printing. ASA may be made smooth by dipping it into aceton for some seconds. PETG may be blown by a hot air gub to get rid of possible burrs remaining from the supports.

PLA is not recommended even it prints well. PLA tends to greep under mechanical load. The spring legs will deform and loose there initial tension after some use. In summer even one use may kill it.