Magnetic PTFE connector

I find it quite difficult to load a new spool with MMU Tower Print Buffer  so a I designed this simple addon that connects the tubes. The hole for the PTFE is an angled so it can snap with its pair 

For 5 pairs of connectors, you need 10 small magnets ( 3mm diam, 1.5mm height - 2$ on aliexpres).

I printed them with 100%infill, 0.2 layer height, in transparent PLA. 

The magnets can be pressed into place using a plier:

I recomend using an m4 drill ($5 on aliexpress) to clear the hole of stringing and ease of insertion by rotating the connector on the PTFE tube: