Customizable angle bracket wedge for Ubiquity Unify G4 Doorbell Camera

This bracket allows mounting the G4 door bell camera with an angle that can be adjusted (in Fusion 360) to required degrees in both vertical (top/down) and horizontal (left/right) direction.

The included stl mounts camera looking 35 degrees down and 5.5 to the left. This enables to see most of my porch as opposed to 50% of the image looking at the sky.

Angles can be adjusted in the included Fusion 360 source file - edit either of the two "Revolve" features.

I found it helps to print the bracket at a roughly "good enough" angle and then make a bunch of small wedges (that is, the bottom of the bracket) in 2.5-5 degree increments. The wedges can be glued to the bracket to play with the angles without reprinting the entire bracket.

Note that the design has only tiny holes marking the location of the screws - these can drilled to the size of your screws. In my case, the bracket is screwed from the back to a mounting plate on the wall of my house, whereas G4 bracket is crewed from the front.

Note 2: the 4 pegs that are used to engage the G4 metal mounting plate might be a bit off or print skewed - I made them smaller to make sure they go in, but you might still need to trim them with a knife.

Prints without supports.