Petlibro (dockstream) bowl clamp

My cats tend to try to pull the bowl of the Petlibro waterfountain, which result in a wet floor. This design clamps it against a wall or furniture.

After 3D scanning the bowl itself i made it a negative resulting in 2 clamps to hold the waterbowl in 1 place near a wall or piece of furniture.

I did left room/a gap between the backside of the bowl itself and the end of the mount, so you can remove the bowl easily.

The notches are a bit roughly scanned at the lower part of the notch, but it will work.

Printing orientation: flat like how you would mount them, with the notches on the upper side. (as/is)