Noctua NF-A20 feet

Remixed mount for the Noctua 200 mm fan (NF-A20) to enable me to places them on my window sill without tipping over. 

To assemble you either need: 

• 2 - M4x40 
• 2 - M4 nuts
• 2 - M4 washers (optional)

or:

• 4 - Fan screws (not tested but should work)

The screw might need to be threaded through the printed holes depending on print settings, a thinker layer height means the tolerances on the hole gets smaller, but with 0.2 mm layer height it's possible to thread the screws through the hole.

Printed mine with PETG with 15% infill at 0.2 mm layer height.