Deathly Hallows Pen/Pencil Holder (v1)

Some funky issues due to messy mesh work in Houdini (it had been a while since I had worked in it last).

Each side panel was printed crest side up to get the best smoothness, though I didn't have ironing turned on. These took about 9 hours each at Cura's .16mm layer height “Dynamic Quality” setting on my CR-10 300. (I had not yet discovered PrusaSlicer :))

The center core took 17 hours on the same settings.

Crest Credits: 

Ravenclaw Crest by Gelap | Download free STL model | Printables.com

Logo of Hogswarts (Harry Potter) by LparisTS1Dpink - Thingiverse

HP Font:  Harry Potter Cufflinks by KhaloodPanda - Thingiverse

Inspired by Harry Potter Pencil Holder by dzsoo86 - Thingiverse

Future revisions will include modeled elder wand (imported), the other three houses, and textured (most likely castle like brick) sides.