Gear Lever for Flight Simuators

A three position gear lever for flight simulation use.

Uses an analog hall effect sensor, for button inputs you can use firmwares such as mmjoy and freejoy to simulate button presses.

I can not guarantee fit and tolerances, use the step file to adapt to your purposes.
This has only been built once for personal use and not tested extensively, not an easy build.

Parts needed:
Allegro A1324 or similar hall effect sensor
2x 6x2mm Neodymium Magnets
4x 11x5x4 Ball Bearing (common in rc cars)
3x M2x4mm Screw (for magnet holder and to retain bearings)
4x M3x8mm Screw
1x M3x10mm Screw
1x M3 Nut
2x rubber band (pull around axle and bearing holder on either side)
CA glue to attach bearing holders, magnets and cover.