The model is tested in "Cura" for printing with plastic filament. Be sure not to use supports on this model. That won't cause the print to fail but it will adhere to the female portion of the treads rendering the print useless.
With the following parameters for PLA:
Layer height 0.08mm or 0.12mm or 0.16mm
Wall thickness 1.32mm
Wall line count 3
Filling density 15%
Grid pattern
Extrusion temperature 200°C
Plate temperature 60°C
Printing speed 50mm/s
Wall speed 25mm/s
Type of adhesion
raft
The author marked this model as their own original creation.