Anycubic Wash and Cure Plus Turntable agitator - various sizes and mods.

under construction. More is coming soon

If you want to replace your agitator, you have to use a material which is resistant to IPA or water. 

For IPA I recommand using PP or PA. If you take a bit more care about it, you can also use PETG. Please check out the resistance graph below:

Source: Prusament.com

For assambly you need the folowing parts:

• 30mm Magnets (Amazon)
• 8x22mm Bearings (Amazon)
• M3 Heat inserts OD 4,7mm (Amazon)

Place the bearing firstly into your agitator. Use a flat surface to press it in. Afterwards, place the heat inserts into your printed part. Then you can insert the magnets and screw it into the threads with the bolts.

If you want to place the Wash and Cure 2.0 Box on a Wash and Cure Plus, you have to use this BOM:

• 5x16mm Bearings (Amazon)
• 30mm Magnets (Amazon)
• M3 Heat inserts OD 4,7mm (Amazon)

Als Amazon-Partner verdiene ich an qualifizierten Verkäufen