Space Base Organizer w/ Card Alignment Helpers and Magnetic Cube Sliders

The awesome parts:

1. It all fits in the original box with the original box insert.
2. Everything needed for 5 players prints with 178g of filament.
3. There are three slots in the top for inactive ship cards.
4. There is an alignment ridge to keep the active ship cards aligned with the board.
5. The resource cubes become sliders using magnets so they stay in place unless you move them.

You will need to print:

• 1x - CubeBoxBody
• 1x - CubeBoxLid
• 2x - PlayerCardStorage
• 3x/player - BoardCardHolder OR 1x/player - BoardCardHolder3Pack (designed to be printed vertically so that the cards slots are extra nice, so only do the three pack if you have stringing eliminated on your printed and material, and your layer adhesion is good, otherwise print horizontally)
• 3x/player - CubeSliderTop
• 3x/player - CubeSliderBottom
• 4x/player - BoardSupport

You will need:

12x/player - 6mm/3mm round magnets (Total: 60x). The magnets gently press in and then I rubbed a bit of hot glue on top of each one to seal it into place, but other glue could be used that would look better.