Desktop Tool Tray w/ Hex Drivers

Made to specifically hold a set of EKLIND hex drivers (1.3-4mm) which can be found here: 

https://www.amazon.com/dp/B0021O1A1G?psc=1&ref=ppx_yo2ov_dt_b_product_details

Each section includes a chamfered front edge to make pulling objects out of the trays much easier.  

0.28mm layer height is fine

15% infill

All cooling fans at 100%

Any filament will do. Printed mine in Hatchbox Blue-Gray PLA. However, for this filament at least I needed to drop the temperature from 220C down to 205C to prevent stringing. 

UDPATE 07.14.2023 - 

Added slots on back trays to allow more air to flow through the part while printing. Seemed to help with stringing. 

Changed the thickness of the tray walls to be stronger/print more cleanly. 

Removed some fillets in certain areas that would not print correctly.

Changed the ID of the driver holders to provide more clearance for the driver shanks.