Pinwheel Kit Card (It spins!)

A small, assemblable pinwheel that can fit in a wallet or an envelope. It's the size of a credit card and 2mm thick, and spins when air is applied.

Enjoy!

How to print

• PLA
• 0.4mm line width
• 0.2mm layer height
• Freshly leveled bed, + a fresh application of glue stick (or whatever other method you use to get good adhesion on a first layer with small details)
• Take care when removing from the bed, making sure various extremities are loose before trying to remove it wholly. The part that might give you the most trouble and is more likely to need individual attention is the ring at the center of the wheel.

Filaments shown in photo(s): Prusament Pineapple Yellow PLA, Fillamentum Extrafill Luminous Green PLA