Raspberry Pi Camera Module 3 Corner Mount Voron V2.4

A mount for a Pi cam 3 to be placed on the front left or right Z extrusions at bed level.
46
322
4
1921
updated September 23, 2023

Description

PDF

Modeled by me but based on the original idea here: https://github.com/VoronDesign/VoronUsers/tree/master/printer_mods/richardjm/picam-corner

I modeled a new one from scratch in F360 because the Pi Camera V3 just fit far too loose for my liking and modding the stl file directly was a nightmare. Fit is still a TAD loose on my prints but wrapping the edges of the camera pcb with slivers of kapton tape before sliding it into place seems to have snugged it up. Figured I'd leave it since a printers tolerances might vary by that amount anyways.

For the Pi Camera 3 if you use Crowsnest for your camera service, you will want the following line in your config: v4l2ctl: v4l2ctl: autofocus-mode=manual, lens-position=4.5

That will lock your focus to the objects on your bed. You may need to play with the lens position value to get it where you want it. That's the value that worked for me on a 300x300. Just bump the value up and down and restart the crowsnest service each time. It will not happen in real time. 

Tags



Model origin

The author marked this model as their own original creation.

License