Skådis / Skadis - Deburring Tool

Use with Ikea Skadis system and T-Clips to mount (see remix section).

Be sure to print a T-Clip to go along with this model.

After inserting the T-Clip fully, turn the printed model on its side, attach it to the Skadis board, and rotate clockwise 90° or until the printed model is in the correct orientation. Do not overtighten the model or the T-Clip might bend/break. If so, simply print a replacement T-Clip.

To remove, turn the printed model counterclockwise 90° and pull outward.