Skådis / Skadis - AirPods Pro 2 Wireless Charger

Use with Ikea Skadis system and T-Clips to mount (see remix section).
Fits Apple AirPods 2 case and provides wireless charging (Apple Watch charger required).

Charger model negative was scaled up by 1% (if I recall correctly) to allow for an easier fit.

AirPods fit comfortably, not too tight or too loose.
Ability to open the case while in the mounted holder to remove AirPods for use.
Included hole for charging light to shine through so you can verify the charging status.

Be sure to print a T-Clip to go along with this model.

After inserting the T-Clip fully, turn the printed model on its side, attach it to the Skadis board, and rotate clockwise 90° or until the printed model is in the correct orientation. Do not overtighten the model or the T-Clip might bend/break. If so, simply print a replacement T-Clip.

To remove, turn the printed model counterclockwise 90° and pull outward.