AeroPress Filter Handle

This is an easy to print handle for tightening the bottom filter cap onto the AeroPress. Its been tested with the old and the new AP Go style filter cap. However, the new AP XL uses a much larger filter cap, so this will not work for that. 

Suggested print settings: 3 walls and at least 30% infill
Wall Generator: Arachne 
Any Material, PLA should work just fine. Be sure to remove the handle after tightening so it doesn't heat up with the AP when brewing. 
NO Supports needed. 
Should be able to print directly to the bed without a brim using PLA.

Please note this is not meant to be used while brewing your coffee. Please use to tighten and loosen the filter cap only. The clearances are very forgiving so you should be able to easily slide it onto the AeroPress.