Webcam Plug - Kit Card

The edges used are multiples of 0.4 mm long. Sharp ends R0.2mm.

To complete the model you will need a tool (e.g. flat pliers). You may need to heat the model if you are using a material that is not malleable. If you use hard epoxy - it will be necessary to cut out the model and glue it.

To make life easier, I've added a 3D model that requires the use of supports when printing, but doesn't require bending.

Stick to the monitor with double-sided adhesive tape.

Bonding with silicone or low temperature glue is less recommended.

WARNINGS:

1. Not suitable for children under 3 years old.
2. If you are not experienced in thermal bending, ask an experienced person for help.
3. Wear safety glasses when cutting plastic.
4. Do not cut plastic when other people are nearby as the shards may injure them.
5. The use of thermal adhesives and silicones carries a serious risk of damage to the camera optics and computer screen housing.
6. Be careful not to cover the microphone.