Samsung Galaxy S22+ Case

Modified the case to include a bigger lip around the display to compensate for the extra height of a screen protector, and be deep enough to provide more protection to the cameras. I initially wanted to add a lip around the camera bump, but that would be nearly impossible to print, so I made the entire back of the case thicker. I also added a small cutout for the bottom microphone, and made the cutout for the top mic slightly bigger. The buttons didn't fit great, so I made the buttons on the case slightly bigger, and it seems to work well so far.

My phone has a glass screen protector applied, and the case protrudes slightly above it. Some improvements I still want to make are to add textured sides, and perhaps make the top lip even bigger. I also want to try to add air pockets in the corners to provide a bit better impact protection.

I printed mine with SUNLU TPU, with 0 bottom layers and 4 top layers, and 10% (would recmmend 20-30 though) Honeycomb infill to get a nice hex pattern on the bottom. Print slowly!

I also included my modified Fusion360 file, but there might be a few broken steps, I don't have time to figure out how to fix it.

Modified the case to include a bigger lip around the display to compensate for the extra height of a screen protector, and be deep enough to provide more protection to the cameras. I initially wanted to add a lip around the camera bump, but that would be nearly impossible to print, so I made the entire back of the case thicker. I also added a small cutout for the bottom microphone, and made the cutout for the top mic slightly bigger. The buttons didn't fit great, so I made the buttons on the case slightly bigger, and it seems to work well so far.