Lowrider v3 - Makita700-hose40mm holder + detachable dust shoe

1 complete setup =

• 1x dustshoe => designed for bosch GAS 15-35 or 55 hose
• 1x LH & RH clip
• 4x TPU bristles (choose 1 out of 4 designs per “bristle setup”)
• 1x Makita-700_hose-40mm holder
• 1x Makita-700_hose-40mm holder-clearance

This part is designed as such that you can print in place without any supports. Due to the clip design it will snugly and without exesive force hold the hose in place and only release when you latch the clip by hand, also with little force. 

2clips: 1 normal and 1 with more offset to the btm to connect to the cup with brush.

Dustshoe with 3 different “brushes” (print 4x per shoe-layout) in length depending what you need / prefer. If you think the brushes are to wide you can cut them so it becomes more like bristles (see picture)

I also added a blank 40mm long “brush” so you can cut  yourself to the desired bristle width. If you need shorter bristles, just cut the model in the slicer. With this design you will have a double row of TPU bristles which should work even better to hold larger debris inside the shoe.

Print the brushes in a TPU so it can easily flex and doesn't create unwanted forces on the X carriage. Insert with some lube into the holder to facilitate the assembly.

I'm using this as I needed a solution to quickly take my shop vacuum in and out of my CNC projects.

Also I didn't like the hose hanging on the side as is made for bad accesebility to the screws to fasten this bracket to the carriage.

IF YOU NEED THIS DESIGN FOR OTHER DIAMETER TUBE, LET ME KNOW i CAN QUICKLY ITERATE IN FUSION.