Ceiling spool holder

I designed this to test if the self-resonating vibrations that come from making fine, fast infill would become better on my Elegoo Neptune 3 Max, which i think they did.

You just need to tap the center hole with an M6x1.0, the hole is 30mm deep. I used a 20mm long bolt. Then i just used regular wood screws to mount the holder to the ceiling, but check what you should use for your ceiling.

I printed with 50% gyroid infill at 0.2 layer height, and i stressed really hard and could not break it apart, but test yours before mounting so that it it doesn't drop your spool on the printer. No supports needed.

I'm not responsible for any damage caused by this design!