Handle with CARE - it's a furniture handle - 128 + 160mm version

I know this is kind of pointless but I think it is very funny.

It is a handle for furniture in the System32-grid, there are versions for both 128 and 160 mm hole spacing. 

I printed it with the holes facing down to the printbed, added a brim and supports on the printbed. Especially for PLA I would suggest at least 4 perimeters for the “legs”. 

Fixes with the standard M4 screws, you might need to re-cut the threads or force the screw into there the first time, then it is very rigid.