Ellis Bed Fan Cover

I didnt really like the look of the fan 5015 on its own, but thought the mount itself was fine....so I made this little cover to go over the top.

There are two versions.

1. The cover with honey comb to try and stop gunk getting in.
2. The cover with open air inlet for better airflow. (Untested, please let me know if there are any issues! )

There is no back so that you can pop this over the top of the fans without taking the bed off etc. (Depending on bed thickness, you may need to change to BHCS bolts for it to work)

You can get the mount to go with this here - Original Mount - Bed Fans by Ellis -

Print in ABS / ASA / PCCF or some other material that can stand the heat of the bed.

Please let me know if this doesnt fit your fan for any reason, while it works for my fans, im sure there are slight variances between fans.

NB: A couple of small edits were made to thin out the front of the cover so it doesnt push the door slighltly open for people that use 1mm door insulation foam, and another to make it easier to remove the backless cover.