Generic USB Power Brick Holder for Skadis

I needed a holder for a generic nameless 195W USB power brick (GaN) charger for a Skadis wall system from Ikea.  I liked how the mount that the Wacom Skadis holder by LucMeister looked, so I used those as the mounting hooks for my device.  The simple chamfer along the edges makes it easy to print.  I pretty much trimmed away everything except for the hooks on the original model, but I wanted to give credit where credit is due.  The hooks were nicely modelled, and it saved me from having to model my own.

Assembly is pretty simple… the USB charger is held in place between two end caps.  Print these with the face facing down, and snug supports for the hook and you'll be fine. The charger will be captive between the two end plates, and none of the ports for the USB devices, or the input power are blocked by the holder.  

I'm not sure if this will be useful to anyone or not, but it seemed like a worthwhile add, and a good way to use up some end-of-roll leftovers that were too long to just throw in the trash, but short enough to not be much use on their own. 

0.3mm layer

15% gyroid infill, 100% infill for the hooks (use a modifier for that region on each of the objects)

3 perimeters

snug supports, build plate only, 45 degree offset, 1mm spacing

I used Overture PLA leftovers from various other builds to clean out my scrap bin, but any filament should work fine :)