No Supports Phone Holder/Stand

This design was inspired by James Hillyerd's model: https://www.prusaprinters.org/prints/40975-no-support-charging-stand/

I originally printed James's model in PETG to satisfy my needs. His model is cantilevered, which meant every time I set my phone on it, it kinda nodded up and down, due to the minor flexibility of PETG. The nodding did kinda bug me so, and while I guess I could have used a stiffer plastic, it still would not have completely solved this minor nitpick.

So I designed my own version from scratch! The two main changes from James's design are a stiffened frame, as well as having the phone sit at a 10 degrees higher angle. It also holds a phone up to 12mm thick.

Print it flat on its side and you should have no problems. Although, I'd recommend you orient the "arms" towards your cooling fan, for better looking overhangs.

Print instructions

Print with a brim, 0.2mm layer height, and 3 perimeters