5" IKEA lack table risers

Ikea lack table risers. 5 inch height so I could fit 2 Home Depot 7gal bins under the table. Great for holding rolls of filament and my 3d printer supplies.

Cutouts in the design were made to save filament and not require supports to print.

Print them upside down with support on the bottom. 46% support overhang angle in Cura should prevent supports being made on the cut outs. Use a brim to prevent lifting and retain dimensional accuracy. Infill I used is 20% and I was able to sit on the table. Printed with PETG.

2x #6 (1.25"-1.50" long) wood screws are needed for each leg.