Quadlock Charger Stand

This is a phone stand intended specifically for the Quadlock MAG wireless charging head, which in turn is for phones equipped with Quadlock cases.  If you happen to use such a phone case and the wireless charging head is compatible with your phone, then this is the phone stand for you!

The model is hinged for portability and printability, and sits at 30 degrees to vertical when in use.  The charging head bolts into the mount and a channel is provided to route the USB cable into the head once it's in place.  Note that Quadlock don't provide an actual nut in the charging head kit - you'll need to source an M5 hex nut.

Since this is a fairly long, narrow print, you might want to print it at 45-degree angle, in which case it'll fit in a 208mm square.

---

585 Quadlock Charger Stand