Magician X2 mini spool holder for 250g spools

The stock spool holder on the X2 is too large to fit smaller spools with a 41.6mm hole. This will snap under the carry handle with a little “convincing”. can be removed in the same manner. Neither the holder or the mini spools will interfere with the printhead at full Z height. Add supports. Only tested on Magician X2.

New V2 prints in two separate parts to print cleaner and makes removing supports much easier. Youll just need an M5x12mm (or longer) bolt and an M5 nut. No sacrifice on strength. Organic supports needed on top lip overhang.

My first upload so be gentle!