E46 ZF 5-Speed Transmission Detent Tool-tray

Fits all the detent tools required for transmission detent servicing on a ZF 320G-S5D manual transmission.

Uses (4) 15mm x 3mm neodymium magnets; Readily available on Amazon. You MIGHT be able to get this thing to stick vertically, but they are really there to keep it in place in a drawer.  

Prints in about 2 hours on a Bambu X1-Carbon. I used Bambu Carbon PLA, but printing in PLA should be just fine. 

The tools fit VERY snugly, but shouldn't “snap” or be forced in. You may have to adjust inner/outer wall speeds and/or layer thickness to make it a closer/looser fit.  

If there is enough demand, I can always optimize the model and reduce the printing time and amount of filament required. But, this was a quick design so it wasn't really a huge concern for me.