Gantry mount for Logitech C310

BOM : 

• 3 x m3 heatset insert (Length 4mm, OD 5mm) - from Voron BOM
• 2 x m3x16 SHCH or BHCS screw
• 1 x m3x6 BHCS
• Original m5 BHCS M5x10 might be too short, so use a M5x12 or longuer

Just disassemble your C310, and keep the cable and the PCB (you can unplug the cable from PCB with the connector on it, for older version without connector you will have to cut the Logitech base of the webcam).

Keep also 2 screws that maintains the cover to the Logitech base, and 2 screws that maintain PCB to the Logitech base.

Put 2x m3 inserts into printed square and 1x m3 insert into the printed male ball and socket joint, assemble with m3x16 screws all the moving parts (composing the hinge), plug male and female of the ball-and-socket joint (have to force a little bit, then rotation should be smoot but with some resistance).

Screw the base to the ball and socket joint with m3x6 BHCS.

Screw the PCB to the printed base, with 2 self tapping screws you kept, and screw the cover with the other 2 self tapping screw.

Attach it on the gantry with m5 screw (as shown on pics).

I used the “logiCam equerre.stl” file as square, but i also uploaded others dimensions squares that could be used depending your needs.

Also since a friend of mine printed the ball joint that was a little bit loose for him, i added two others maleball joint file in case you have the same issue. I used the "Rotule male 8.8 file", but if that's a little bit loose try the 8.9 version, and if it is hard to move try the 8.7 version.

Enjoy !